Under the ice socks knitalong part two: working the foot

Hello, and welcome back to the second part of the Under the Ice sock knitalong. We finished last week with a little sock toe in blue, with a provisional cast on in white, like below.

Before you can work the foot, you need to unpick the stitches of that provisional cast on. Hopefully you took my advice and cast on in a different and lighter colour, because that will make unpicking these stitches so much easier.

Set yourself up so that you can reach the provisional cast on stitches with one empty metal needle. The other metal needle will be closer to the blue toe stitches that you’ve just knit; don’t use that end.

Make sure that you have the correct side of the toe facing you (i.e. it is the right way out), and work from the left to the right. Insert your needle into the first blue stitch before you even start to unpick the white yarn. You can see this in the photo below. I’ve pulled the white yarn out a bit to make it clearer for you.

Now that you’ve got that stitch safely on your needle, you can pull that white yarn all the way out. There will still be a second bit of white yarn in the stitch.

Now pull the white yarn through the rows of white, where it is being held in place:

and all the way out of that stitch.

Now you can move on to the second stitch, and do exactly the same thing:

Keep doing this until you have worked your way through all the stitches. You will get to a point where you think you are probably done. The white yarn will still be attached to your sock. Resist the temptation to pull it out! Count your stitches carefully. This is the stage I’m at in the photo below:

When you count your stitches at this point, you’ll find that you are still one stitch short of the number you should have. That last bit of white yarn is holding the last little very-hard-to-see blue stitch. Find it, insert your needle into it and then pull out the end of the white yarn. That’s it! You’ve unpicked your provisional cast on. Your work should now look like this:

Arrange your needles so that the stitches you’ve just picked up are on the metal needle, but the stitches on the other side of the toe are on the plastic part of your circular needle. You should have a loop of plastic sticking out of the other side of the toe (to the left of this picture).

Insert your free end of the needle into the first stitch, ready to knit it. Your needle is now set up ready to knit on a magic loop, and your working yarn should be attached to the stitches on the plastic part of the needle. When you make your first stitch on this side, make sure that you pull your working yarn nice and tight, to stop there being a gap up the side of your sock.

Now all you need to do is knit round and round the stitches, moving the needles round in magic loop each time. That means that each time you finish a row, you put the other stitches onto the metal needle end closest to them and shift the stitches you’ve just knitted to the plastic part of the needle. You should have the two needles working on one side of the sock, and a plastic loop of needle sticking out on the other side.

In the photo below, I’ve just finished a row and turned my work so that the stitches I’ve just knitted are at the back.

Then all I need to do is pull the plastic part of the needle until those stitches at the front are on the metal part, ready to be worked, and pull the needle through the stitches at the back so that that end of the needle is free and ready to work those front stitches:

Make sure you pull the working yarn tight on the first couple of stitches of each new row. Keep knitting until your sock is long enough. That will be when it reaches the point where the top of the foot turns into the bottom of the leg, when you try it on.

Madeleine

Happy knitting! The foot is a fun and easy bit, so enjoy knitting your way round and round this week.

 

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.